Hello! You wanted to get into the settings of your modem or WiFi-router using its IP-address – 192.168.1.254 and you obviously could not log into the system. Do not rush to close the page! Spend a couple of minutes and read the instructions below !!!
Most likely, this problem with access to the configuration of your ADSL modem, WiFi-router or optical GPON terminal via ip 192.168.1.254 (input to the TP-Link router, ASUS, Zyxel) or 192.168.ll will be solved quickly and easily. And most importantly, you do not have to call a third-party computer master who probably can not do anything, but he will still demand money for the services.
So, the cause of problems with entering the system settings of the router or optical modem terminal through 192.168.1.254 admin / admin can be a variety of various factors, from a banal input error to the failure of the most wireless router or modem. Let’s try to figure out the problem together and solve it together.
What is a router and what does IP 192.168.1.254?
Let’s start with a little theoretical digression. To date, most cable access devices to the Internet, ADSL modems, optical terminals ONT and even some 3G / 4G modems have basic routing functions and are rightly called routers or western routers or routers route – route). In fact, this is a sort of separate mini-computer with its operating system, which controls the device.
Any router must have at least two network interfaces – an external WAN and an internal LAN – and therefore there is an IP on each of them.
The external address of the device is received from the communication operator to which it is connected. But the internal address is used as a gateway for connected computers, laptops, tablets, telephones, televisions and other. It is usually used as IP 192.168.1.254 – the input to the router TP-Link, Zyxel, Asus, Netgear, TTnet, branded modems and routers from telecom operators Rostelecom, Dom.ru and Beeline. Accordingly, the subnet used on them is 192.168.1.0/24 . It is used on all computers, laptops, tablets and smartphones connected to it – hence the dhcp-server of the network device issues dynamic addresses to clients.
Sometimes, however, some manufacturers use the last iphone to enter the router in the range of 192.168.1.254 – this is often the fault of the Chinese manufacturers Huawei and ZTE. In principle, this is normal and there are no problems in the operation of the device or the operation of the services. The main thing is to set everything correctly on the connected machines or correctly configure the DHCP server.
Less commonly used is another IP and subnet 192.168.0.1 with a mask of 255.255.255.0 . These are mainly D-Link devices, Tenda and part of the TP-Link lineup. On wireless access points from Dlink can also be different.